Questions & Answers for: Dell what is a jumper plug

...refer to the Manuals. Use the PSWD jumper, and put it on the RTCRST jumper for 5 seconds. Put the jumper back onto the PSWD pins. Plug the power cable into the computer. Turn on the

...jumper plug from its pins. 3: Place the password jumper plug on the RTC_RST pins and wait approximately 5 seconds. 4: Remove the jumper plug from the RTC_RST pins and place it back on the password ...

...CMOS jumper (RTCRST) on the system board. Remove the jumper plug from pins 2 and 3. Place the jumper plug on pins 1 and 2 and wait approximately five seconds. Replace the jumper plug on pins 2 and

...jumper plug from pin 1. Place the jumper plug on pins 1 and 2 and wait approximately five seconds. Replace the jumper plug on pin 1. Replace the computer cover.[Click here] Hope this HELPED ...

...CMOS password reset jumper on the system board.Remove the jumper plug from pins 1 and 2.Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.Replace the jumper plug on pins 1 and

...jumper plug, usually beside where the cable plugs in but sometimes on the opposite side. The jumper options are usually listed on the drive but what you will need to do is place the jumper plug ...

jumper plug on jumper A to pins 2 and 3 to disable the password(s).Turn on the computer. Powering up the system with jumper A set to the disabled position erases existing password(s). Before assigning

...jumper plug from pins 1 and 2. Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds. Replace the jumper plug on pins 1 and 2. Close the computer cover. And More Support see link:- ...

...plug into my sata hard drive and do I need a jumper on sata hard drive and what setting would the jumper go on A sata drive doesn't need jumpers. The jumpers were only required when 2 drives used the ...

...jumper plug. Locate the 2-pin CMOS jumper (RTCRST) on the system board. Move the 2-pin jumper plug from the password jumper to pins into the CMOS jumper. Plug in AC power to the system and wait ten ...