Questions & Answers for: how many u joints are on a truck

Question about 2003 Suburban 1500

1 Answer

2003 suburban how to replace lower left ball joint Jack up the affected side and support vehicle on stands. Remove nut that fastens onto affected ball joint; Using a "pickle fork" (ball joint ...

Ad

Question about 2004 Tacoma

1 Answer

replace ball joints how do you replace ball joints in 2004 tacoma 4x4 Remove in this order: wheel, loosen the 4 lower ball joint set bolts, cotter pin and nut from tie rod, tie rod from ball joint ...

Ad

joints on a 2003 Ford Sport Trac? if you dont have a ball joint press and dont know how to use one then dont do it, but if you do its not that bad of a job just jack the truck up under the control arm

...joints on 1997 dodge ram 1500 jack up truck support truck remove brake caliper and support the caliper dont let it hang by the hose remove cotter pin from bottom of ball joint remove castle nut from ...

Question about 2004 Alero

2 Answers

...have other questions. One would have to remove the half shaft to service the cv joint properly. CV-Joints Overhaul Check the CV-boot for wear Removing the outer band from the CV-boot Removing the ...

cost to replace ball joints 2001 Ford Expedition Eddie Bauer 4WD Click this help links below to go through its complete replacing procedure :-----Upper Ball Joints inspection and replacement? ...

How to replace ball joints on a 1998 mercedes benz s420 For ball joints issue.Before replacing it,first inspect and test the ball joints to confirm the problem:----Click the help links below to ...

...a CV joint goes bad. Constant Velocity joints and U-joints perform a similar function, but are not really the same thing. U-joints are more typically used on rear-drive or truck-based 4WD

joints on a truck that old, I suggest you do them all at the same time. You'll need a special tool called a ball joint fork. You remove the cotter pin on the nut that holds the ball. Then you position

...joints. The official manufacturer torque spec. for lower ball joint wear (For your truck) is 5 in lbs. The official wear spec. to pass the Federal State inspection is less than 1/16" of play at the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...