Questions & Answers for: jeep stalls in reverse

...grand cherokee laredo whenever i try to reverse my jeep will stall and then when i get it started again a little bit of white smoke comes out of it..what could be wrong with it? it might be ur ...

...Jeep GC limited stalls ONLY in reverse I have a 2004 Jeep GC limited with inline 6 it has 90,000. It just started to stall when its shifted into reverse, get NO check engine light and NO code. Runs ...

...jeep cherokee sport 4.0 Litre. Problem is it will start and idle just fine, but when engaed in drive will stall and then not re-start for a 5 to 10 minute period of time. Will Idle and even run in ...

...jeep has difficulty starting up when cold then stalls out when excellerating or driving and will stall out when put in reverse. We have changed the fuel filter which seemed to help a bit, could it be ...

...put it in my 1993 grand cherokee jeep stalls when i put it in reverse. what can i do? Check the crankshaft position sensor mine was doing the same thing also make sure there is nothing rubbing ontop ...

...jeep grand cherokee limited stalls while driving or at low idle speed also has stalled in reverse. i have changed the ignition sensor and the crank sensor. and it still stalls. need help. need help ...

Jeep Wrangler X 4x4, 4.0 Starts and runs fine until shifted into Reverse, the it stalls and dies immediately. Just after it stalls, a vacuum line pops off of the intake manifold, and the warm air hose

jeep stalls or runs ruff when shifted to reverse tranny was rebuilt not sure if bands were adjusted properly transmission Hello. Your engine might be burning transmission fluid when shifted into ...

...jeep grand Cherokee cuts off when I put it in reverse engine stalls.? what cuts off, the radio:? transmission slips (cuts has no real meanings, to ...

stalls when I first start it up and I shift from reverse to drive . Changed plugs,wires distributor cap,rotor,coil pack,crankshaft sensor and still nothing. Any ideas please? Jeep ???? grand cherokee