Questions & Answers for: jeep liberty flush

Question about 2005 Liberty

1 Answer

...Jeep Liberty (2WD). When I'm the heater blows out heat just fine. BUt if I'm sitting still, e.g. at a stop light or in traffic All i get is cold air. Is this a thermostat problem or is it time for a ...

Ad

...Jeep Liberty I have 70 thousands mile and they said i have water leaking in the engine the suggest a full flush of the engine is this normal No, this is not normal. if you have coolant or water ...

Ad

Question about 2002 Liberty

1 Answer

...heater in my 2002 jeep liberty stopped blowing hot i flushed it and changed the thermostat and still no heat what could be the problem? the motor for the heat door is bad no switching from cold to ...

jeep liberty 3.7 leter engine. Is draining and jeep liberty 3.7 leter engine. Is draining and flushing the coolant a different process than the basic automobile? Are there details that need to be ...

...Jeep Liberty Sport with 162,000 miles. While driving with the heater on, it smells like either oil or steering fluid burning. Took car to repair shop, everything checked out fine. Any ideas? I have a ...

...Jeep Liberty with over 100k miles. The previous owner admitted they had not kept up with servicing the vehicle since about 50,000 miles. What do I need to get checked? Are there Is there anything ...

...jeep liberty 3.7, heater blows only warm air. Changed themostat,flushed heater core...flows clean both ways, flushed radiator clean. All hoses to and from heater core are nice and hot about the same ...

jeep liberty run hot ,but when i turn the A/C on it wan,t run hot 2006 jeep liberty run hot when the A/C not on runs hot, so how much, use a meter? full flush the coolant system yet. test the Radiator

...Jeep Liberty only blowing cold air? Element in heater blown , could be independent fuse for heat also , check fusebox check coolant level if ok make sure engine temp is normal if ok check both heater ...

jeep liberty replacing ac compressor, need ac lines blown out You have to get a special solvent. You put it in the lines to flush them out. Make sure that you have removed the orifice tube. http://www

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...