Questions & Answers for: jeep commander remote door locks

remote for my 2000 jeep grand cherokee wont unlock the I have a 2000 jeep grand cherokee and the keyless remote wont unlock the doors and when I hit the lock button it doesnt chirp like it used to and

...Jeep Liberty Doors wont lock, radio doesnt work. I was snipping my constant 12v wire and the wire hit the back of my factory radio, after it hit the radio quit working, my remoteless key wont lock or ...

...said possibly problem in pass door module where remote feed is but windows and locks all work good. wont program remote. If battery has been replaced in remote,press unlock 6 times then test ...

...door locks have a remote section and a hardwire section. The hardwire section works because unlock/lock of the drivers door commands all the others but the remote section (electric motor - push/pull) ...

...jeep. and now my keyless remote doesn't work? jow do i get it to work? test battery of your remote controller. then check connection just you did. if lock electronics/window are out of order ...

...jeep commander will not start. Everythin turns on, lights, radio, ect... just wont start engine. Any ideas? Im thinking maybe something with my security system. But i really dont know. and my key ...

...Jeep Commander just in a fender bender. Tried to start the car with the phaub outside of the car. The doors lock but the car doesnt start. There is a red light that comes on the dash that I looked up ...

jeep commander I don't know if my alarm is on or not.Alarm indicator light does not flash when I push the remote lock button, if I push the panic button it goes off. Tried to set it off by putting the

...jeep commandor alarm lock vehicle with either remote or use lock button on door inside car...then goto passenger side door and unlock it with key..this should reset it 1st i sent my computer and had ...

...jeep liberty 2004, the doors work with the remote except the drivers door an the rear swing gate the glass latch works with the remote but the door latch does not open most likely a wiring problem ...