Questions & Answers for: jam 2 blinking pairing

...2 common problems that bring up the "Clear carriage jam" error on different printers, both to do with gears, which are unavailable to replace- on the d135 a lower gear on the cleaning station that ...

...2) locate the switch, and (3) put the spring back into the correct positiion. uninstall it and reinstall it, hopefully it will reset itself then. just had the same problem with mine....it said Paper ...

...blinking. Initializing says print cartridge error when pressed any button says busy and running comment as see the product documentation for details. There are several different ways I've come across ...

...2) paper jam, or (3) ink out or (4) carriage error. (1) and (2) should be evident to you, so I presume it could be (3) or (4). For (3), a faulty cartridge could also cause this, so change the ...

...2 minutes and finds the paper jam. So be sure to give a serious lookover 2 or 3 times, and get a fresh pair of eyes on it if you still cant locate it. This generally indicates a paper jam. I had this ...

2. Press the "OK" button on the control panel to pretend the paper jam is cleared. 3. CAREFULLY OBSERVE THE pair of white gears on the left, if they seem to clutch, stall, skip or freeze then you have

...jam anywhere in the machine.. look inside, rear, where the paper tray (output) is, etc to see if you find any shreds or torn paper that may have gotten stuck and you didn't see.Look carefully in the ...

...Jam or the output tray is closed. * four flashes means the ink tank is empty * five flashes means the print head is not installed correctly or not installed or is defective (before buying a new print ...

jam speaker is paired with my galaxy tab 2. I have been using it To listen to music and it has been working. I turned the speaker of and a couple hours later went to put it on again and when I did the

...2 red lights blinking!on same circuit as paper shredder,whitch was jammed & triped the circuit breaker several times,then phone went dead! You probably just need to Pair the handset with the base ...