Questions & Answers for: where is the jack located Music

can be bad solder joints on the circuit board where this jack is located. Another cause is a failure of the jack itself. If you are capable, Take the circuit board out and have a look. Hope this helps

Ad

Question about Xenyx 1002fx Mixer 10 Input 2 Bus with Efx

1 Answer

jack, which is located just to the left of the MAIN OUT jacks. If your headphones have a 1/8 inch jack, you will require a 1/8 inch female to 1/4 inch male stereo adapter. These are fairly common, and

Ad

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

1 Answer

How to play with headphones If you have a preamp output jack or a headphones jack on the back- those will work.  They should interupt the speaker if you are wanting it for practice purposes.if ...

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

1 Answer

...jack. Remove plastic electronics cover plate, located on the back of the body, behind control knobs. This will expose the electronics cavity. Locate existing jack and its wire connections inside the ...

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

1 Answer

How do Ireplace dc power jack Yamaha psr-550 Open up the keyboard, locate the power jack, remove board, turn over, unsolder, purchase new jack, resolder, reassemble. Power jacks have a habit of ...

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

1 Answer

...to in a behinger europower pmp 2000 mixer amp What are the correct main speaker cables and jacks o be used here and where are the main inputs located.Thankyiu The Behringer PMP2000 uses ...

...jack located on the rear of the keyboard. Does it seem to be loose or does moving the power supply jack up/down cause any change? New wall-wart power supplies can be purchased from Radio Shack and ...

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

1 Answer

...located and mark where it needs to exit. drill a hole just large enough for the wire to pass through. Check where you want to install the output jack. If in the side, drill a mounting hole. If you're ...

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

3 Answers

...jack located on the back of the keyboard. You can connect a standard sustain pedal to this jack and use it to sustain notes while playing. When you plug in the pedal, make sure the keyboard is turned ...

Question about Orange RK50TCMKII212 Rockerverb 50 MKII Guitar Combo Amplifier (50 Watts 2x12 in)

1 Answer

...located on the rear panel or sometimes underneath the amp. Keep track of the screws and their locations. Accessing the Input Jack: Once the chassis is removed from the enclosure, you should have ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...