...to replace the motor mount but I am wondering wut is the easiest way to do it. You just have to jack up the engine under the oil pan. Then simply unbolt the mount bolts. Some guys think it is ...
...located at bottom of engine in the very rear of the engine, one end goes into the bell housing of the transmission. U will have to jack the car up to access the starter. For safety sake use jack ...
...located just above the rearend assy on the body on the car. Obviously safety first, jack the vehicle and make sure its secure and blocked to prevent being crushed and make it unable to roll away. ...
...combination and can be removed from the long bolt/stud that is attached to the seat track rails. Jack the car up high and set on jack stands to get enough room to lie underneath the car. Be
...pump, the pump located inside the tank. Remove your backseat if there is a hole, if not, you need to bring it down the tank with a floor jack with the wood.. There are two bolts and two straps too. ...
...spring unless you have a coil-over set up. Meaning your strut is inside the coil springs. Putting a jack under the control arm stabilizing the coil so it doesn't pop off. Also you raise the jack at ...
...located on the passenger side along side the oil pan of the engine but mounted to the bellhousing of the transmission. It is difficult to see from up top because of the exhaust manifold or header. ...
where is fuel filter located on 1991 Mustang LX convertible??caanrban Probably on the frame rail 3/4 of the way back,jack up car & follow fuel lines till you find it .
Question about 1966 Mustang
jack up the front of the car and get underneath the car to see it, as it's located below the exhaust manifold on that side. If you don't have this site for Mustang Enthusiasts, bookmarked, you should!
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions