...front of the engine compartment. One or two of the middle row plugs can be accessed most easily by jacking up the vehicle and removing the front tires. Make sure you follow all safety procedures and ...
...hoses they may have a restriction causing Sounds like a rotor/wheel bearing, not a brake problem. Jack up the wheel, and turn it (Spin it) and see if it feels ruff or sticks as you turn it. Then ...
...jack anywhere in or on the van nor a suitable place where one might be stored. Thanks. It should be located on the right hand side fender wall on most Chevrolet / GMC Vans. Another location it may be ...
...new fuel filter, and has spark and fuel. What would be next in line to check at this point? Thanks, Jack If it is getting spark and fuel check the timing. The timing chain may have jumped.Take out #1 ...
how to replace iddle arm and pitman arm on a 1986 g20 van jack up and support van passenger side first with wheels straight remove wheel unbolt idler arm from center link and using a fork designed for
...located on the rear inner frame just before the gas tank on the passenger side of the van just follow the fuel line to the back . its hard to get to the location where its mounted and you have to ...
...need a helper. The door needs to be supported while you drive the pins out, I use an old bumper jack but any jack will do the trick. The helper steady's the door so it doesn't twist. There should ...
speedodemeter stopped working not the fuse have removed guage ciuster but do not know where speed sensor is located If the VSS sensor was bad you should have a check engine light on if the truck ...
where would the starter for a chevy g20 conversion van be located? Starter located under engine on passenger side where engine and trans. meet.
where is location of ecu 1995 chevy g20 v6 4.3 where is the ecu located Under the drivers seat.
Usually answered in minutes!
216 Questions
140 Questions
122 Questions
99 Questions
91 Questions
