jack car and use axle stands to support the car. 2 remove wheel 3 behind drum or disc break assembly you will see shock absorber assembly 5 remover lower but (it may be very tight due to corrosion and
...front bumper and get a better look, it is normally pretty easy to access by the front air vents... ...
...LOCATED? Where is my oil filter located? Is it a cannister or paper filter? Is it easy to change? cannister...easy as pie...you'll need to get under the car using ramps and/or jack and jack
...JACK STANDS.REMOVE THE SPLASH FROM BELOW THE ENGINE.DRAIN THE COOLANT FROM THE RADIATOR.NOW V6 ENGINES .PLACE THE RADIATOR SUPPORT PANEL IN THE SERVICE POSITION.FOLLOW THE LOWER RADIATOR HOSE TO THE ...
how to remove the tire rod end on a 1998 a4 audi Jack up the car and support the car on the frame allowing the suspension to hang free. Locate the inner part of the tie rod and loosen the adjuster ...
my will start but wont move my audi will start but wont move I jacked it up and took off all four tires and only the front two hubs and back right will move any ideas? sound like center differential ...
...is a starter issue, where would the starter be located and is it an easy task to complete with simply a jack? Thank you for your time. Any codes? could be the crankshaft sensor.battery and
Oil change How to do-it yourself oil change jack up your car, and always put jack stands or at least some concrete blocks under the frame of the car, for safety. then locate the bottom of the oil pan,
tank (in front of right rear wheel) and can be physically pulled down for replacement (requires car jacked up)
Question about 2014 Q5
...jack the vehicle up -keeping it level - run the motor until the trans is at a specified temp as indicated on VagCom - and fill the trans until the fluid drips out of the top hole. ATF filter (as on ...
Usually answered in minutes!
786 Questions
747 Questions
638 Questions
616 Questions
604 Questions