Questions & Answers for: jack 1993 grand

Question about 1993 Grand Am

1 Answer

1993 grand am TOOLS FOR THE JOB: jack jack stands sockets and socket wrench safety glasses PROCEDURE: 1. raise your car at all four points, with jack stands 2. drain your oil 3. there will be multiple

Ad

Question about 1999 Grand Cherokee

1 Answer

looking for the wiring diagram for the transmission for a jeep grand cherokee 1993. specifically the two round female jacks. one has three slots go to the parts store and buy the repair manual for SUV

Ad

...1993 jeep grand cherokee, want to know how hard it is and if i can do it or has to be done my mechanic because of special tools needed. Make sure you use lots of wd40 or other solvent on strap bolts. ...

...jack on my 1993 grand wagoneer Heard it may be under the back seat....how do you remove the seat? You will find two release loops on the sides of seat Part closest to back rest comes up, back rest ...

how to change a fuel pump on a 1993 mercury grand marquis Empty the gas tang ,jack up the car losen couple screws let it slowly disconnect the wire. The fuel pump located in side the tang.

...1993 Mercury Grand Marquis disconnect battery,,jack car up,,put jack stand on frame,,take starter bolts out,(may not be easy),,take wires off starter,,hoped it helped,, My car does not start when I ...

Question about 1993 Grand Cherokee

1 Answer

1993 Jeep Grand Cherokee Laredo 4.0L 6L Auto Trans. Turns over but wont start No spark on plugs, good compression. Just put new ignition coil, rotor cap plugs plug wires. but, checked power supply to ...

Question about 1993 Grand Cherokee

1 Answer

...now i have a nock coming from the rear end. what could b the problem? Your best bet is to just jack that baby up, climb underneath it and see what is ...

1993 Pontiac Grand Prix 3.4 idles very high when cold. About 3000 - 3500 RPM. It then slows down to normal once fully warmed up. Any ideas? It does not turn on a check engine light at all. OBD 1 it ...

...1993 jeep grand cherokee, i need to know how to get the old ones off and 2 new ones on. please help. you will need a small floor jack or at least a bottle jack and a small peice of 2x4,, remove nuts ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...