Questions & Answers for: intake bolts

Question about 1996 Mustang

1 Answer

...intake manifold on one of the bolts when engine is beginning to start. What is causing this? Either the intake bolt is loose or the gasget is broke by that bolt. But most likely the intake is cracked ...

Ad

Question about 1999 Regal

2 Answers

...intake manifold bolts and carefully lift off the manifold. To install: Fig. Lower intake manifold bolt torque sequence-3.8L (VIN K) engine Clean all parts well with degreaser, especially the gasket ...

Ad

...clockwise ⑭ Intake manifold collector: Bolts and nuts: 8 ft. lbs. Stud bolts: 61 inch lbs. ⑮ Intake manifold: Bolts and nuts: 5 ft. lbs. and than to 21 ft. lbs. Studs: 8 ft.

intake manifold bolts torque and rocker arm torque engine specs Intake Manifold Coolant Pipe Bolt .... 89 in lbs (7.4166 ft. lbs) Lower Intake Manifold Bolt .............. 115 in. lbs (9.5833 ft. lbs)

intake manifold bolts (the four middle ones) to 7 Nm (62 lb in). Tighten the diagonal lower intake manifold bolts (two on each end) to 7 Nm (62 lb in). Tighten the vertical lower intake manifold bolts

Question about 1997 Grand Prix

2 Answers

...bolts. Lower intake manifold. Lower intake manifold seals. Lower intake manifold gaskets. If replacing the lower intake manifold, Remove or disconnect: Water outlet housing bolt and stud Water outlet ...

Question about 1996 Blazer

1 Answer

...intake manifold bolts. Install the lower intake manifold bolts. Notice: Proper lower intake manifold fastener tightening sequence and torque is critical. Always follow the tightening sequence, and ...

...30 N?·m 22 lb ft Intake Manifold Bolts (First Pass in Sequence) 5 N?·m 44 lb in Intake Manifold Bolts (Final Pass in Sequence) 10 N?·m 89 lb in Intake Manifold Wiring Harness Stud 10 N?·m 89 lb ...

...intake bolts and Torque the bolts , starting from the center and working your way out in a circular pattern Torque these bolts in a few small increments until they have reached 250 inch pounds of ...

...Bolts Manifold Spark Plugs Lug Nuts Intake Exhaust 1998 2.4 (2389) KA24DE 1A Step 1: 22 ft. lbs. 2B 10-12 ft. lbs. plus 60-65 degrees or 28-33 ft. lbs. 3 4C The cylinder heads and the lower intake ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...