...rear wheel Remove the brake hose (A) from the suspension arm by removing the brake hose clip (B).Thoroughly clean the outside of the caliper to prevent dust and dirt from entering inside.Support the ...
Install New Rear Brake Pads After the caliper has been reset, reinstall caliper mounting bolts and make sure the bolts are tight. Then match up the old brake pads to the new brake pads. They should be
...Install the rear pads on the caliper support. Install the rear caliper on the support. Install the 2 mounting bolts, hold the slide pins and tighten 25 ft-lb (34 Nm). Fill the reservoir and bleed the ...
...rear caliper mounting To Install: Install or connect the following: 4 pad support plates on the rear caliper mounting Pad wear indicator plate on the inside brake pad Note: Install the pad wear ...
...rear wheel and tire assemblies Drive out the brake pad retaining pins from outside-to-inside then remove the pins and retaining spring Remove the brake pads Inspect the following: Brake pad retaining ...
...rear disc. Install the rear brake caliper mounting bracket. Torque the bracket bolts as follows: TMC made (Japan): Torque the bracket bolt 46 ft-lb (61.8 Nm) TMMK made (Kentucky): Torque the bracket ...
INSTALL NEW REAR BRAKE PADS.TO REMOVE REAR PADS ONCE YOU COMPRESS PISTON BACK IN THE CYLINDER BORE. YOU CAN TO REMOVE REAR BRAKE PADS BY REMOVING RETAINING PINS IF EQUIPPED OR BRAKE PADS HELD IN PLACE
Question about 2003 VL 1500 Intruder LC
...install new pads.... Remove the old brake pads...Coat the brake pad pins and the new brake pads metal back plates with high-temperature grease. Slip the new brake pads into the rear brake caliper, ...
...rear of the motorcycle, install the new pad and install but do not tighten the pad pins, then pump the rear brake pedal to move the inside pistons out until they they contact the inside brake pad, ...
...rear caliper. Install new inside brake pad using the same orientation as the pad previously removed. Curved portion of pad must face upward. Install pad pins until the pins snap into place with an ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions