Questions & Answers for: install lower ball joint

...Install the lower ball joint and J9519-E, J41435, and J45105-2 to the lower control arm. Install the lower ball joint to the lower control arm using J9519-E, J41435, and J45105-2. Remove J9519-E, ...

Install is reverse but don't tighten the 4 lower ball joint set bolts. torque is as follows: ball joint to control arm- 112 ft-lbs Tie rod nut- 67 ft-lbs lower ball joint set bolts- 83 ft-lbs remember

...lower control arm. To install: Install or connect the following: Lower ball joint to the lower control arm, using tools J 9519-E, J 41435 and J 45105-2 Remove the tools from the lower control arm. ...

...lower arm, dust covers, and bushings for damage and wear. Installation To install, reverse removal procedure. Use NEW ball joint nuts. Lubricate lip and inside of dust cover with multipurpose ...

...lower control arm. Install a new ball joint-to-lower control arm nut. Tighten the stabilizer shaft bolts to 35 ft. lbs. (48 Nm). For 1988-91 vehicles, tighten the ball joint-to-lower control arm nut ...

...Install the lower ball joint into the steering knuckle and secure it with the nut and bolt. Tighten the nut to 32-43 ft. lbs. (43-59 Nm). Install the wheel and tire assembly and lower the vehicle. ...

...lower control arm To install: Attach the new ball joint to the lower control arm with 3 mounting bolts and nuts. On Deville and Fleetwood, the bolts must be installed from the top of the control arm. ...

...lower control arm.Install a NEW seal boot by hand as far as possible on the ball joint. Installation of the seal boot is to be with the shield positioned as shown. CAUTION: Do not use an arbor press ...

...lower ball joint into the control arm using a ball joint installation tool. Remove the block of wood supporting the upper control arm. Install a new cotter pin through the ball joint stud.Install the ...

...Install the lower control arm (2) to the front suspension support (1)Notice: Refer to Fastener Notice in the Preface section. Install the lower control arm front (5) and rear (4) mounting ...