...fuel line. how is the best way to analyse fuel problem. thank you, mac You could try and prime the carburetor and start the saw. If the saw starts for a short while, but dies, than it probably isn't ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...fuel supply line and fired it up. it went straight to full power without me squeezing the trigger. this is too dangerous and i need info on how to resolve this problem. If you had this apart, a few ...
chainsaw i have fuel coming out of my muffler Most likely you have a hole in the diaphragm inside carburetor on needle is sticking remove carburetor and clean install carburetor kit.
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...install as before. If you originally got good spark, place little fuel mix in the plug hole and retry start--it should at least pop several times. If so, check the fuel filter, air filter and muffler ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...These are know for the fuel line problems. Pull out the fuel line from the tank with the filter and check it. I've fixed 4 or 5 with bad lines. While your add it you may want to install a new
Question about 2.0/14" Chain Saw Misc. Parts Lot
fuel line on a Craaftman 2.0 14 This is an older Craftsman, the guy atthe parts counter told me it was actually manufactured by Poulan take the new hose trim it back to 1/3 of its the dia about a 1/2&
...install a new carburetor repair kit,because the diaphragm will get hard and that will cause it to be hard to crank.The diaphgram may look good and flexible, but it can be deceiving and not act as a ...
Question about Sears Chain Saw Manuals Model 358.360360
...install a new carburetor repair kit,because the diaphragm will get hard and that will cause it to be hard to crank.The diaphgram may look good and flexible, but it can be deceiving and not act as a ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...fuel line can be retreived and install the new filter on the line, slowly pull the fuel filter back into the fuel tank,leaving some slack in the line to not kink the line.Please take time to rate ...
...install a new carburetor repair kit,because the diaphragm will get hard and that will cause it to be hard to crank.The diaphgram may look good and flexible, but it can be deceiving and not act as a ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions