Questions & Answers for: install a flapper

...flapper). Install flapper and adjust the float fairly close to the flapper. When the water level drops in the tank and reaches the level of the float on the opne flapper, the flapper quickly closes ...

2 new toilets installed. customer complaint of occasional clogs. no apparent problem although i feel the flush valve closes very fast. any changes or adjustments for this Hi, Often I change the ...

...and use the hinges on the sides to install. Other than that make sure your flapper chain is straight and not twisted and also that the chain is giving the flapper a reasonable slack. Hope this

...to replace the flapper. turn water off, remove old flapper, wipe port off with rag where flapper seals, adjust chain to same length as old flapper, install new flapper. fluidmaster is the best

...turn the water off, remove the old flapper, adjust the chain on the new flapper to the length of the old flapper, wipe the port area where the flapper seals to remove residue, install new

I have installed a Fluidmaster 403 G fill valve, flapper and tank lever to the water tank in my toilet. The tank fills OK but after several minutes the water in the tank has drained out I can not see ...

Installed a new Kohler wethworth toilet. Every 2-5 min the water refills in short spurts. Is there any reason, flapper defective? Water level in tank might be set too high, allowing water to drain out

...leaks into bowl replaced with new 540 flapper and it still leaks Check if flapper is correctly installed,. check if it doesn't have some "protective" sticker which should be removed before ...

...incomplete flush. Replaced with new red Korky, and adjusted chain tighter AND looser. Something was installed prior to my being called in to correct the problem of partial flush. Is something ...

Just installed new Korky flapper and seal, it all seems centered well, but the flap doesn't seem heavy enough and almost floats, so the tank won't fill. Is it possible to weight it down? Theoretically