...inside of microwave oven be dangerous? Yes, you can paint over the spots and no, it's not dangerous. I'd let the paint thoroughly dry before using the oven -- it could otherwise cause paint to ...
...inside the microwave oven I have rust forming on the inside corners of my 15-year-old Panasonic Microwave Oven. Is this dangerous? Is heating food safe? This is just okay but if you're quite doubtful ...
Question about General Electric Microwave Oven
...inside badly rusted - oven works fine Old GE - works fine but bottom of door rusted very badly. Can I paint it? Yes you can paint it.. Begin by removing the rust with either a wire brush or a thick ...
Rust marks on inside trim My microwave has a small rust mark on the door & the inside rim. When I open the microwave door the marks are on the trim near the hinges. The marks are not actually on ...
Question about MW8102SS 1100 Watts Microwave Oven
...inside microwave oven bottom is peeling paint inside microwave oven is peeling The oven cavity will probably start to rust where the paint is gone. If you're up to it, sand it and paint it with a ...
...it before it goes rusty You can buy enamel paint , depends where the rust is, you can buy heat proof paint if it is inside the oven. If it is outside then treat it with a rust inhibitng paint
...inside oven has de-laminated and rust is forming under coating. Warranty? Hello spark... no warranty unless the microwave is under 1 year. If there is a lot of rust and delamination you are best off ...
Question about Appliances Over-the-Range Microwave Oven
...oven where the floor meets with the back side, there seems to be some rust. is this a problem? It is strange as the inside of micro wave ovens are usually stainless steel. Clean off the rust, you may ...
...microwave oven. Usually the inside is made with stainless steel and does not rust. Are you sure that it is rust? Could it be built up grime? If it is then use some Fantastic and wipe it away. Good ...
...given off during cooking. If your fan is not working or your vents are blocked, the moisture stays inside and hence; rust. You could repaint by doing a bit of sanding and using a tremclad rust
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions
