...ideas? I already jacked it up and nothing seems loos. I am preparing to replace CV joints/boots (inner and outer). Try doing it in park to make sure it does not do it while you're in motion. The ...
my 2005 pacifica the door is making a carnking sound only when you open the door some WD40 or similar lubricant sprayed directly on the door hinges (try to spray the inners of the hinge with the WD40 ...
...seems to be one more on the outside edge of the lens there is and its hidden it should be on the inner panel outter edge towards the ...
jam nut on inner tie rod to outer loose. 2. Remove nut from outer tie rod attaching it to steering knuckle. 3. Use hammer to get tie rod out of knuckle. 4. Unscrew outer tie rod then jam nut 5. Remove
...under the vehicle and release the boots or retaining bolts holding the shaft into the spyder or inner CV joint. Once removed pull the half shaft out of the housings keeping everything as clean as ...
passenger window off track Not off any trackIf you remove the inner door panel,you will see the problemYou most likely have a broken window regulator,& will need to buy that at a dealer in most ...
fix pacifica stuck in park Are you parked on a significant incline? You may need to have your car CAREFULLY pushed slightly uphill by another vehicle while moving the shift lever. Not on a hill or a ...
would bad inner tie rods cause abs light to come on? Most likely not. Does it come on as soon as you start the cr and never go off or does it come on when you start for a couple of seconds, then go ...
see where the old battery ground bolted to the side of the transmission. You may have to remove the inner fender to gain access to it
...2006 PCM location on Chrysler Pacifica 2006 ,3,5l If I remember correctly, it should be behind the inner wheel liner on the drivers side behind the bumper. Just pull the drivers wheel and the liner ...
Usually answered in minutes!
1,141 Questions
1,029 Questions
504 Questions
133 Questions
44 Questions