ok. let me know if you have any problems or questions and ill be glad to assist you ok. not all hdi injectors are the same and there are some tricks to replacing the injectors so be careful as you can
...injector seals. Just wondered if replacing seals and washers on the injectors is an easy job or are there problems I could run into doing this job.Would really appreciate any advise .Can anyone send ...
...injector ? Any other ideas ? (Nb low temperature cooling fan not working so car gets hot in slow traffic or on idle) Thanks Peter Heaps I have 1996 Peugeot 406 (1.8 16v) and it's ignition coil pack ...
...injector seals are leaking then obviously pressure leaks. Clean your turbo sorrounding and check the leakage of oil. In solenoid area If its not enough to drip down or just a little amount that sits ...
My 307 hdi does not accelerate properly My Peugeot 307 HDI used to de celerate on long journeys and then when the engine was turned off for a minute it was ok. Now it barely accelerates from start ...
...Many possible faults, main ones are:- Air or water in the diesel. Use of Biodiesel/veg oil Faulty injector (uncommon) Crank Sensor Leaking injector sealing washer. Lift pump in fuel tank has broken ...
I have a peugeot 306 2001, 1868cc diesel engine and at times there is a crackling noise and engine seem to lose power - then the sound goes and it works well again. The noise is like puttung nuts and ...
...injector or faulty glowplug causing unburnt fuel to damaged turbo oil seals or damaged turbo itself. I have no starting problems and drop in performance that I can notice. Any ideas? If it is the ...
Question about 1989 405
...injector seals, advanced solenoid actuator diesel valve on the bottom of the injector pump. problem is now that i start the vehicle it runs very rough like a misfire or running on just 3 cylinders. ...
Usually answered in minutes!
451 Questions
103 Questions
805 Questions
164 Questions
