just died I HAVE A 97 BLAZER LS WITH A 4.3VORTEC SPYDER INJECTION. SUNDAY I CAME BACK FROM DAYTONA PULLING MY 18 FT BOAT AND HAD NO PROBLEM.I BACKED IT IN THE YARD AND DROPPED THE BOAT. 35MIN LATER ...
...i just recently replaced the rear main seal and front and rear trans seals fuel pump, filter and injectors. the other day i put discount gas in it and it hasnt ran good ever since i put fuel
...INJECTOR RETAINING CLIP AND NEW O RING SEALS.LUBRICATE O RING SEAL WITH A LITTLE ENGINE OIL.YOU HAVE TO BUY O RING SEALS AT THE DEALERSHIP.BEFORE STARTING THIS JOB YOU NEED A REPAIR MANUAL.IT WILL BE ...
diagram on how to remove and install a spider fuel injector core on a 1994 chevy blazer s10 Here is the removal procedure, and the procedure is the same for both the V-6 and the V-8 Vortec engines. ...
...spark to both, compresion is at 150 psi, air checked cylinders and it with in spec. turning off the injectors with a scan tool makes a difrence on cylinders 3,4,5,6 but not 1 and 2 cylinders. ohm ...
...test the fuel pressure regulator Get a fuel pressure gauge and connect it to the rail for the fuel injectors to read pressure. If the pressure is too low, it might be a bad fuel pressure regulator
...the key is turned to the "Run" position, the on-board computer turns the fuel pump on and opens the injectors to add fuel for starting. Start the engine and check for fuel leaks. Waterbed Pump Video ...
1989 chevy s10 4.3L 4x4 (automatic)Truck idles and runs great when cold. As soon as it reaches operating temperature It acts like it's not getting enough fuel. It will have an erratic idle and when I ...
...hold it down to the lower intake you may have to use a small amount of prying force to get it off the injector assembly. there is a rubber o-ring that seals the 2 together. good luck hope you get
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions