Questions & Answers for: injector seals Cars & Trucks

...injector seals. Just wondered if replacing seals and washers on the injectors is an easy job or are there problems I could run into doing this job.Would really appreciate any advise .Can anyone send ...

is also equally important that old seals are not left behind in the manifold when you take out the injector. Seals should always be replaced. A height mismatch usually means missing or redundant seals

...old seals. Clean the injector are very well with a solvent. Apply Vaseline to the seal mounting area on the injectors. Install the seals and coat them with Vaseline Install the fuel rail and your ...

...seals. Fuel injector clamping plates Fuel injector connectors Fuel cross over elbow Fuel pressure regulator Fuel lines Engine appearance covers Negative battery cable Start the engine and check for ...

how to remove injector once fuel rail is free. have fuel rail up but cannot get injector off it... they just pull out, they are tight because they have o-rings that seal them into the bore. The ...

How do I change the fuel injectors in my 1994 ford Thunderbird lx v8 remove fuel rail remove injector hold down bolts, work out injectors by twisting to free up seal, install new seal on new injectors

...seals in order for the injector to seat into place You need to replace the seals. If you replaced them and they still don't seal, replace the fuel rail. This is a fire just waiting to happen. Grease ...

injector seals Injectors shouldn't leak oil around their seals. It's a good time to clean the area leaving it spotless and monitor to see where the leak is coming from. It could be the recent seal job

...2 eng what can it be an how to fix it. possible injector leaking or seal under injector tip leaking if which injector is not obvious , you may be best to get new seals and overhaul all of the ...

injector seals as needed. Refer to Fuel Rail and Injectors Cleaning and Inspection. Note Inspect the injectors to be sure that they are clean and free of debris prior to installation. Do NOT lubricate