Questions & Answers for: Peugeot injector seals

...injector seals. Just wondered if replacing seals and washers on the injectors is an easy job or are there problems I could run into doing this job.Would really appreciate any advise .Can anyone send ...

...injector ? Any other ideas ? (Nb low temperature cooling fan not working so car gets hot in slow traffic or on idle) Thanks Peter Heaps I have 1996 Peugeot 406 (1.8 16v) and it's ignition coil pack ...

...Many possible faults, main ones are:- Air or water in the diesel. Use of Biodiesel/veg oil Faulty injector (uncommon) Crank Sensor Leaking injector sealing washer. Lift pump in fuel tank has broken ...

...diognostic light on and have almost no power but engine still running and spluttering poss number 4 injector due to water ingress in to wiring plug through o/s/f washer jet seal on the bonnet verry ...

...its weird some days feels like it could cut out. they have problems with water ingress in to the injector closest to the timing belt and would replace this and to stop the water ingress you need

...injector or faulty glowplug causing unburnt fuel to damaged turbo oil seals or damaged turbo itself. I have no starting problems and drop in performance that I can notice. Any ideas? If it is the ...

...max. fuel is leaking into the sump if diesel it will be from the pump and if petrol will be leaking injector ...

...injector seals, advanced solenoid actuator diesel valve on the bottom of the injector pump. problem is now that i start the vehicle it runs very rough like a misfire or running on just 3 cylinders. ...

injector seals Injectors shouldn't leak oil around their seals. It's a good time to clean the area leaving it spotless and monitor to see where the leak is coming from. It could be the recent seal job

...405 injection is bringing too much fuel, ending up wetting the plugs? what is the problem? problem injectors problem fuel pressure regulator leaking seals under injectors run the fault ...