Questions & Answers for: Chevrolet injector seals

...seal or the injector itself, the seals are replaceable and cheap, just lube the new one with vasoline before installing it, if that does not cure the3 problem you will need to replace the

...at highway speeds ?? Mary, Sounds like you have a lean missfire issue that may be caused by a dirty injector or possible air or vacuum leak at or near the injector. The injector is seated in a ...

...you may have a leaking one. If so try and determine which one, pull the plug off, remove the injector. Your local auto parts should have a seal kit. Replace seals (o-rings), and replace

...INJECTOR RETAINING CLIP AND NEW O RING SEALS.LUBRICATE O RING SEAL WITH A LITTLE ENGINE OIL.YOU HAVE TO BUY O RING SEALS AT THE DEALERSHIP.BEFORE STARTING THIS JOB YOU NEED A REPAIR MANUAL.IT WILL BE ...

...old seals. Clean the injector are very well with a solvent. Apply Vaseline to the seal mounting area on the injectors. Install the seals and coat them with Vaseline Install the fuel rail and your ...

fuel injector leaking most time its just a seal around the injector, remove it and have it checked, if good replace seals

...to see if the o-ring seals are leaking where the injector goes into the fuel rail.if you don,t see it with it running watch the injector as some one else shuts the car off and look for bleed

...that is blowing out blue smoke. Mileage is 371,256 Any ideas You will need to have the injectors and injector seals checked and if it is a turbo you will also need to have the turbo seals

replaced injector and pressure reg now new injector is overflowing bowl flooding whats up with that does it happen if the injectors are unplugged ? could be a problem with the gasket or seal for the ...

How do you replace fuel injectors in 2005 Chevy Colorado? remove the bolts that hold the fuel rail. Lift the fuel rail, pulling the injectors out carefully. Make sure the rubber seal comes out with ...