...lamp infocus 540 still will not fire up what is wrong Hi there You should reset the lamp timer as this LCD Projector's counter counts down the hours and will not fire up if this has not been done. If ...
Infocus 540 lamp didnt strike keep trying it will not fire up help me if mains is ok and fan running ok, could be a bulb service issue, all lcd projectors have an internal lamp life counter which ...
Question about LP120 / 1000 Lumens / XGA / DLP Projector Refurbished Multimedia Projector
...there is a solution. Thank you! Louis Usually when the lamp is good and you get this message, the ballast is bad. That is the part thatdrives the lamp. Check with Infocus for a repalacement balast. ...
infocus lp 540 lamp didn't strike Also having this problem."Warming up" then "lamp didn't strike" then "retrying" stuck in a loop. It's at a school where I work and nobody has reported any messages ...
infocus 1 red light blink lamp is not striking after 5 tries. try new lamp. if it still doesn'r work, you need to have the ballast replaced. Hello, This means that the lamp didn't strike after five (5
...Strike Lamp will not strike in LP600. Receive message "Powering up...Wait..." then "Retrying". Eventually, a message is displayed "Lamp Did Not Strike". The cycle just repeats over and over again... ...
Infocus SP5000. The unit turns on,but the lamp has stopped working. I took the lamp unit out and it looks perfectly fine. I suspect the lamp hour counter has exceeded its suggested life and is keeping
Question about LP70+ Multimedia Projector
lamp. otherwise, you'll want to replace the ballast. you can send it in for repair (or buy the part and do it yourself) from an infocus service center. try av solutions in ny. they're really good. www
...InFocus lp600 won't strike. I replaced the lamp but it still will not strike. Any ideas? If you replace the lamp but do not reset the lamp hours then the projector will not ignite the lamp to stop it ...
Question about LP640 Multimedia Projector
projector has not been pushed in as I have seen this happen on a couple of LP540 and LP640 projectors. If the connector is pushed in the connector on the lamp will not make contact and strike the lamp
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions