Questions & Answers for: impact screwdriver

...impact wrench looks like a fat screwdriver; on the end where the screwdriver blade normally goes, you can snap on screwdriver bits or sockets. my impact when the press the trigger the air come from ...

impact screwdriver. You should be able to pick up a cheap one from your local parts store. You hit the impact screwdriver with a hammer and it forces the screwdriver bit to turn. But make sure you are

...If you have two batteries, do you have same problem with both batteries? If so could be weak battery had same problem with new Bosch impact screwdriver a while back. New Li Ion battery was

...impact driver and it is stuck tight. VERY GENTLY. . . . use a flat tip screw driver to try to push the collar forward so that it will release the bit. You may need to gently hold the handle of the ...

...shaft pully use a impact driver or have someone hold the flywheel with a screwdriver best sugestion I can give is use an impact gun or take it to a repair shop they can atleast bust it loose for ...

impact mode, just stops like a normal screwdriver. Both batteries tested 15 plus volts. any answeres? could be a problem with the impact hammer, I would suggest removing the front housing to make sure

...Impact Wrench Mine had a metal ring on the end that held the sockets on. I also had the same problem as you but what I did was took a flat screwdriver and removed that clip ring. I did that because I ...

What does a DW9107 screwdriver look like, where can I purchase, and how much does it sell for? Where can I find a DW9107 screwdriver to open bottom of my 19.2 charger? What does it look like? Maybe ...

shaft. Barry You could use an impact screwdriver. Use a #3 phillips bit if the screw is large. You smack the end of the impact screwdriver with a hammer and the action pushes in and turns on the screw

screws on Michael Kors watch please? You need jeweler grade screwdrivers if the head is messed up, tap and turn like an impact screwdriver. If the thread is stripped, the only way is to drill them out