Questions & Answers for: Chevrolet 2500 ignition switch

Question about 1989 C/K 2500

1 Answer

ignition switch is good, the ignition coil is good, when I turn the key I get a single click I replaced the battery, the starter and the starter cyclinoid, what could it be?? could be bad ground?get a

Ad

my avalanche just cut off on me and wont crank. i have eliminated battery, fuel filter, fuel pump, stater, alternator, spark plugs and wires have u ck the ignition switch

Ad

Question about 1989 C/K 2500

2 Answers

...to push the plate down so a clip can be removed. There will be a screw in the right upper corner under a small brass tab that holds the switch in , remove the screw and the ignition will slide

...ignition switch and tested computer it is ok has a new oil pump fuel pressure shut off switch new distributor new alternater and still no fire Did your old igniton switch require a key with a "chip" ...

...ignition switch ,now three wires to worry about the permant 12v feed ,then the power to the ignition and then the starter ,now with ignition off find the feed wire then turn ignition on and find the ...

Question about 1989 C/K 2500

1 Answer

lighting or even installed a discreet ignition interrupt switch to prevent theft. Your best bet would be to try to trace where the wires go after they leave the switch and see if that offers any clues

Ignition Switch Support 89 chevy I am unaware of what you are refering to with "ignition switch support". The ignition switch is attached to the steering column near the bottom (close to the firewall)

...ignition switch and its wiring harness, and the ignition lock cylinder and nothing has fixed the problem pity you did not get a load test on the battery first dead cells or bad terminals will do what ...

...ignition switch is in the ACCY or ON position. The driver master control switches are integrated into the DDS. When a power window switch is activated in the up or down positions the DDS supplies ...

...ignition switch. There are dealer bulletins on this were they bypassed the ignition switch with a relay or just replace the switch. If the fuse is ok and has power you need to disconnect the trans ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...