Questions & Answers for: Saturn ignition relay

i replaced the ignition switch and lockset and key and now it starts but wont stay running fuel pump relay needed if the engine only runs a few seconds and quits

...ignition or the starter relay is fried. yeah no click or anything that could mean the starter solenoid is not working need to check and make sure your getting voltage to the starter solenoid if you ...

...relay or solenoid is energized by voltage from the ignition switch circuit, it closes a contact that routes more power from the battery directly to the starter to crank the engine. The starter motor ...

...relay, engine computer, etc.) - Ignition system problems, especially on older vehicles with the distributor (e.g bad ignition coil, commutator, rotor, distributor cap, etc.) - Defective ignition ...

...It is a Pass lock problem.. GM is notorious for using sub-standard dy-electric grease in the Ignition switch box, and it doesn't always make good contact. Therefore the computer thinks the ...

...fuse), then work back to the ignition switch and the body control module. Wish I didn't have to say that, but yes, the BCM is between the ignition switch and the run/crank relay. Good luck,

...relay box. If the car is not spinning over and the battery is good , you may have a security system fault. Is the security light on or flashing when you turn the ignition on? If so, the security ...

stalled no power to ignition batt ok fuses and relays ok Take off the battery connectors & clean them. If they are corroded beyond useful replace the wires.

...Ignition switch it still won't start and I replaced the starter relay it still won't start and when I cross the starter with a screw drive it started saturns are known for this. they have a safety on ...

...ignition transducer that engine crank has been requested. The BCM verifies that theft is not active and sends a serial data message to the engine control module (ECM)/powertrain control module (PCM) ...