...Ignition switch not on. 3. Discharged battery, loose or corroded connections. (Solenoid chatters.) 4. Starter control relay or solenoid not functioning. 5. Electric starter shaft pinion gear not ...
...ignition module . The relay is attached to relay connector located to the right of the battery underneath the seat. Pull relay from relay block. . Connect positive battery lead to the 86 terminal. . ...
...Ignition relay, the engine will turn over and the fuse is fine until I replace the relay. Tried swapping relays and got same results. The fuse blows because of the amount of current being drawn ...
Question about 2000 S3
...relay clicking when key is turned on. Hi, Anonymous and the usual suspects are: 1. Fuel tank empty. 2. Fuel supply valve/petcock turned off. 3. Fouled spark plugs. 4. Engine flooded as a result of ...
Question about 2005 Firebolt XB12R
Relay replaced 6 monthss ago but doing it again Hi, Anonymous and the usual suspects are: 1. Ignition Switch not in the "ON" position. 2. Engine Run Switch in the "OFF" position. 3. Discharged battery
...ignition relay, check for continuity. 6. Failed ignition coil, ignition/electronic module. 7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets. 8. ...
...ignition relay, check for continuity. 6. Failed ignition coil, ignition/electronic module. 7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets. 8. ...
Question about 2005 Lightning XB12S
ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position. 5. Faulty starter button/switch. 6. Faulty jiffy stand or clutch pull in switch/sensor. 7. Security alarm
...ignition relay, check for continuity. 6. Failed ignition coil, ignition/electronic module. 7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets. 8. ...
...ignition relay, check for continuity. 6. Failed ignition coil, ignition/electronic module. 7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets. 8. ...
Usually answered in minutes!
100 Questions
64 Questions
56 Questions
50 Questions
45 Questions