Key will not engage ignition switch. Turns and gets power but stops at the ignition. If you can't turn the key all the way to start, you need either a lock cylinder or an ignition switch...maybe both.
how do you replace a ignigtion lock cylinder on a 1998 dodge it is a caravan . tilt stering wheel I can't figure out how to remove the old one to replace it. REMOVAL: NOTE: The Supplemental Inflatable
i have a 98 dodge caravan and when i put the key My son was playing in my 98 dodge caravan and when I got the key from him it was bent. I bent the key back and when I put it in the ignition it won't ...
key goes into ignition with the greatest of ease. Sometimes wont start the car, sometimes will. Do i need a new ignition? Could this be expensive or maybe just something simple wrong? Car is 5 years ...
how to replace ignition There are a couple of different scenarios if I remember correctly. If you have a key that will turn the ignition cylinder then it will be easy. Follow these steps. 1. ...
how to remove my key lock 2000dodge caravan Ignition Lock Cylinder - Removal & Installation CAUTION The Supplemental Inflatable Restraint (SIR) system must be disarmed before working around the ...
no spark,no power to ignition module,already replace cam and crank sensor but still no power to ignition module,and no spark Have you pulled codes to see if anything comes up? check to see if you have
replace ignition switch on a 1999 dodge caravan Take off the plastic housing around the column. then thke off the light ring around the ignition switch. on the underside of the ignition switch ...
Question about 1999 Caravan
In my 1999 dodge caravan the ignition only turns the engine over after repeated attempts. I checked all the connections on the battery and the starter and they are good. I replaced the starter and ...
Usually answered in minutes!
2,271 Questions
1,496 Questions
1,337 Questions
1,299 Questions
1,150 Questions