Questions & Answers for: Troy-Bilt idle surges

...surges at idle or any speed That is called hunting and can be caused by various things. The governor controls the engine speed. Is the lever and link/spring correct. Carb in good shape? Spark plug ...

...adtusted Hold @ full throttle and adjust high (H) screw until she raps out to max RPM, let off, if idle is rough adjust low (L) screw until idle is achieved, You should have it, if not, clean carb ...

...carb,and installed a carb.kit.Can`t find any vaccum leads, flywheel and key ok .Help thanks The idle screw may be turned all the way in on the carb adjuster which should be a very small screw in

I can get my trimmer started but when I try to accelerate the trimmer from idle it stops sounds like typical carburator issues.Pull carb apart and clean jets if it idles than slow jets are good so its

runs for 10 minutes and stops When running is the idle smooth or up and down? Is the chock operating, or adjusted after the motor gets warm? Is the carburetor needle adjusted after the engine idles to

why does the honda engine surge I have two pressure washers and honda engines on both. Carb needs to be cleaned I would bet,had to on both of mine. Good luck.

My Troy bilt squall 2100 snowblower does not idle steady. It races and slows while idling. How can I get it to idle steady? It sounds like the carb needs cleaning and readjusting, or the fuel filter ...

How can I get my snow blower to idle in a steady fashion? When idling it seems to race and slow. Tune up and carb adjustment. There are two screws on your carb which control the low end(idle) and the ...

How do I fix a surging Tecumseh engine on my 1988 Troy-bilt rotor tiller? It takes a few pulls to start. After it starts, it must stay on full choke to run. It then surges the whole time, and dies ...

...surges. Could it be the governor or idle jet?l you could try opening up the idle/mixture screw another turn to make the transmission from idle to throttle better governors just open the throttle ...