...idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well. < < READ CLOSELY > > Be sure to put these two screws back in the same hole they came ...
Question about 2006 FXDI35 35th Anniversary Super Glide
idle, screw the idle mixture in until it just barely "bottoms" in the hole. Back it out 1 1/2 turns on the "butterfly" carb and about 3 turns on the "CV" carb and start the engine. Adjust the screw to
idle screw and volume control screw (side of car) Blow through all hloes (body and removed jets) with carb cleaner. Also check that fuel supply valve in top of carb is not blocked. Refit all jets. For
...idle screw, but it doesnt help. first drain your float bowl. you may have water in the fuel. if this doesn't help then you must clean out the carb. you will need a can of spray carb cleaner. remove ...
...tight. Put the carb back on the engine. Start the engine and bet it ot operating temp. Adjust the idle mixture screw for the best idle and then set the idle speed at about 1000 RPM. Good Luck ...
kids took carbs off now carbs shot gas and oil in air breather you have two screws one on right hand side in one in between carbs it says its a 650xs4 here the ser number jya12r006da101817 Ok try this
...fuel control screw. It may be necessary to adjust both but try the idle screw first. It may need more adjustments as it warms up. Just mess with it until it idles thr way you want it. Hope this
...Idle Screw (Air/Fuel Mix): The idle screw, also known as the pilot screw, adjusts the air/fuel mixture at idle. It affects the fuel flow from the pilot jets (idle jets) into the carburetors. Locate ...
Question about 2003 VT 750 C2 Shadow
...idle adjust screw and pilot screw (hopefully pilot fuel screw since s I have Yamaha YD 125 motorcycle (4 stroke). It is installed with Ucal Mikuni carburetor. It has mixture adjusting screw on bottom ...
...idle screw. Then gun unit at high speed and turn high screw for maximum rpm. Go from idle to max and make sure there is a smooth transition. If not play a tad with the idle mixture screw till that is ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions