Questions & Answers for: idle adjustment 2006 yamaha ATVs

adjustment on carb would fix this? Thanks, John John replace the idle jet $5.00 at a Yam. dealer (don't try to clean it ) & make sure that the idle mixture brass screw on the bottom of the carb is

adjustment was needed so i cleaned it out and tryed it, runs good at half throttle or over u can puch it full works good but to puch it at idle it back fires out the carb and spits out gas plus i cant

...idle mixture adjustment on the bottom of the carb. is set 3 1/2 turns out from seated in (a brass screw ---Don't over tighten & break off the needle tip). Also , be sure the choke is all the way ...

atv big bear 350 won't idle after cleaning sounds like your mixture was leaned out because ur filter was cloged up ...making it run rich so was adjusted by screwing air screw out, now uv cleaned it, ...

yamaha big bear 400 wont idel and the red revers light blinks idle control is sticking need carb adjusted or float maybe

...carb Engine is idling to low won't stay running The adjustment for the idle would be on the side of the carb. sometimes just as a phillips screw and sometimes as a knob that is on a cable type

how to adjust the carburetor on a yamaha YZF450R 2006 How do i adjust the carburetor what are you trying to adjust? idle, air, fuel?? refer to shop manual for specific settings

do I need a special screwdriver to adjust the carb on a 2006 Kawasaki bayou 250. not idling right after cleaning. no. idle is a thumb screw on the side of the carb. (I think, mine was an older model)

I have a 06 yamaha wolverine 450 4x4 and when i go from neutral to forward it dont wanna go in gear unless i bump the throttle a little any ideas? lever might need adjusting. check all your fluids too

idle and will not maintain and dies. get a colortune tool.it shows how your firing.read instructions that come with,so simple to tune carb in with.sounds like pilot out of adjustment.could also have a