Questions & Answers for: Polaroid ics 30

Volume problem After a few days, the volume decreases almost to zero. It doesn't affect the output to the stereo, just the TV speakers. And, if i unplug it for a day or so, it's fine again for 3 to 5 ...

Tryed menu adjustments, still no sound. can hookup extra amp. get sound picture great. the audio out on the back of the set is a pre amp signal. it can be amplified.the internal drive ic that drives ...

power not returning fuse ok, power between the first resister and the resistor next to oscilator ic falls in one side but the rest of power flows normally, except that high viltage can not be ...

power stops only in the power unit the ic TOP 210 was blown but when replaced, still nothing happens.(GOODMANS TV) Replace the Power Supply, had that issue about a month ago and found one supplier of ...

How do i get back to AV1 on my TV? if av1 has stopped working and all others are still working then it is a problem with the switching IC or interface ic so you will need to reploace the mainboard you

what is wrong with my television when I have no picture but have sound? The Video IC may have gone. In electronics nothing can be guaranteed. A component may last for 20 years or it may not last for ...

The internal speakers/sound have quit working. I can hear the sound if I put my ear right next to the speakers but it does not respond to volume control or nay other controls in "settings". Any Ideas?

Why are the speakers not working? The volume button works. Hello, First You need to check if the cable that is connecting Your device o any outer source is properly connected, once that is confirmed, ...

I have a Polaroid HD TV / Monitor its on the Configuration page and I can't get it off it, I can't seem to exit out of it now, I have the correct remote. when it goes to channel installation ...

...to connect but then says out of range or authentication failed If the tablet is running Android ICS and you use secure your wireless network this is the issue. It's a bug in ICS. You will have to ...