Question about 50EX01B 50" Rear Projection Television
...IC module part number is and where I can get it? My problem is similar to other posts; Curved line on the bottom bowing towards center. The Hitache 50EX12BA uses 2 IC's labeled STK392-110. If you are ...
...part number on an IC that is burn so bad. I really would like to have a dirgram of the set. But since I can't find that then it is just replace to part, if I can get the part number. That Part is ...
IC Part Number 23905094 (STK392-110) using the revised ?T? version IC Part Number 23135090 (STK392-110T). When Convergence Output failure is detected, it?s recommended that both IC?s be changed to the
...a part number tv mitsubhishi wt 22311 need a vertical ic number Check Mitsubishi convergence IC's check this link http://www.mitsubishi-tv.com/ service/parts for details on the part number for the ...
Question about 43FDX20B 43" Rear Projection Television
...43FDX20B Replacement Part IC If you contact them and provide the generic number or location number of the IC, they should be able to provided you with the needed parts. alternate/replacement of ...
Question about 43FDX20B 43" Rear Projection Television
...ic board to control colors and pictures. you can get any part you need for your model at the following link. Just hit the contact us button on the lower left side of the page and leave them a email ...
...IC part number. I want the regulator ic part number but can find it. Where is it located? There are many regulator IC in TV you can find it easy the commonly used are 3 pin part number is 4 digit ...
Question about 61HX70 61" Rear Projection Television
IC Part Number 23905094 (STK392-110) using the revised ?T? version IC Part Number 23135090 (STK392-110T). When Convergence Output failure is detected, it?s recommended that both IC?s be changed to the
IC Part Number 23905094 (STK392-110) using the revised ?T? version IC Part Number 23135090 (STK392-110T). When Convergence Output failure is detected, it?s recommended that both IC?s be changed to the
I changed my two IC chips and three resistances on my Hitachi TV to fix color alignments. Now the problems is that yellow and blue double image are seen at the bottom of my screen with no much effect ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions