Question about XL-2100U Projector Lamp for KF-42WE610, KF-50WE610, KF-60WE610, KDF-60XBR950, KDF-70XBR95
...31, 2009. bypass thermal fuse, and door switch. if you still have problems either replaced the G1 board. (Power Supply) or replace the bad ic labled mcz3001. sonys are know for this ic to be
...MCZ3001 or MCZ3001DB will wrok just fine. What I do is install a footing first and simply plug the new Ic in rather than subject it to all the heat. Also check R8051 (fusible) for open. Good Luck! ...
Question about KP-53XBR300 53" Rear Projection Television
...two mcz3001 ic's on the d or dz board, this is a common problem they have used this circuit for years, so the exact board number may be diffrent, but it will be located on the board with the
Question about FD Trinitron WEGA KV-36FS120 36" TV
...if it sits for about 16 hours then it turns on This is a power supply problem, it is the regulator ic's on this board, and a couple of caps that need changed. Sony has used this power supply over ...
...parts on the infamous D-Board (I have some solder/desoldering skills) or replacing the whole board, And what parts. I get 7 blinks most of the time sometimes 6 blinks. Thanks change both mcz3001 ...
Question about FD Trinitron KD-34XBR960 34" TV
...ic's have failed. the part number on them is mcz3001. They are located on the "D" baord, i don't recommend replacing this yourself because even with a tv unplugged from the wall high voltages still ...
Question about FD Trinitron WEGA KV-36HS510 36" TV
...no its not at the end of its life its most likley the power supply there are a couple regulator ics that cause the set to not start up and then some times at random it will start when tried and ...
Question about FD Trinitron WEGA KV-36HS510 36" TV
and bad outcomes. I was for any suggestions, I would appreciate it. Thank you You have problem on power supply section.In most cases regulator ic and ic Mcz3001 is faulty. you need to replace these ic
Question about FD Trinitron WEGA KV-34HS420 34" TV
...be a mcz3001 or str ic or mxoa ic. Check for 160v across the main capacitor for 160v to see if your power supply is working. Do not use chassis ground. Use the ground on the
Question about FD Trinitron WEGA KV-32FS120 32" TV
My sony trinitron will not turn on, only blinks. How can I fix this? ic in power supply ..mcz3001
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions