IAC motor I have a 94 chev lumia APV 3.8 liter. IAC motor goes to high RPM on start up and will not lower. Have changed IAC, Hooked Scanner to Van and tryed to control IAC manualy with no change. ...
...IAC motor in or out to adjust engine idle speed by controlling engine idle air. An IAC motor is highly susceptible to carbon and coking build up; if an IAC goes too long without cleaning it can cause ...
...IAC motor. Disconnect air plenum (where applicable). Remove two mounting bolts (screws). Remove IAC motor from throttle body. To install: Install IAC motor to throttle body. Install and tighten two ...
...IAC) motor is located on the side of the throttle body. Disconnect electrical connector from IAC motor. Remove two mounting bolts (screws). Remove IAC motor from throttle body. Fig. To install: ...
...IAC motor and require only a VOM. Ignition must be OFF . Disconnect the IAC motor connector. Disconnect the PCM harness connector(s). Measure the resistance of the four IAC motor wires between the ...
...IAC motor operation IAC motor (K61) IAC motor control circuit shorted to ground (K961) IAC return circuit open (K961) IAC return circuit shorted to ground (K61) IAC motor control circuit open ...
...IAC motor pintle and allowing more air to pass through the port, or it can be decreased by restricting the passage with the pintle and diminishing the amount of air bypassing the throttle plate. The ...
...IAC motor is usually mounted on the throttle body (click over image for zoom) Disconnect the negative battery cable. Remove the air cleaner intake hose. Remove any necessary hoses from the IAC motor. ...
Question about 2000 Cirrus
...IAC motor or idle air control motor, heres a little info.about the part.Stratus Sedan, 1999-2005Idle Air Control MotorDESCRIPTION & OPERATIONREMOVAL & INSTALLATIONPrintDescription & ...
Question about 2000 Cirrus
IAC motor. If that doesn't clear up your problem. Replace the IAC motor. The reason for opening the throttle is because it is either dirty or the IAC motor is bad. There also could be wiring issues to
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
