Questions & Answers for: Suzuki RM-Z 250 hyt cam

I need to adjust the valves on my Suzuki rm-Z 250. Can you tell me how? To adjust your valves you will need a few standard tools and most importantly a set of feeler gauges. You can buy these at any ...

could you guys illustrate to us the correct timings for the camshaft of kxf25o dirt bike? We can't seem to fire up the bike hope to hear from you we are eager to fire up the bike. Thanks Set your ...

It start whith that the suzuki was harder and harder start every day and one day it wont start att all. I have no Compression so i take the bike to a dealer ho fix the valve clearens, test and change ...

I have an 04 RMZ 250 I just re-shimmed the valves and put a new piston in and bike was running great started first kick road it all over the street and golf course. went on ONE ride in the heat and ...

250 RMZ engine torque specs. what do you need to know? head barral is 38nm and cam carriers are 10nm most 6mm nuts and bolts are 10nm. hope this helps.

2006 rmz250 When I torgue the cam bearing 2006 rmz250 When I torgue the cam bearing journals on the exhaust cam the cam turns very hard. The intake cam tightens just fine. The previous owner said it ...

the driveshaft will not turn If the kick starter operates normally the likely cause for a transmission lock up is bent shift forks. The bent forks are trying to engage two speeds at once i.e., 2nd and

Started hearing alot of top end noise, Valves are in spec ok, But did notice some metel dust on the outside end of the intake cam lobe. Can anyone tell me what i am looking at. I have a 2007 RMZ 250 ...

i a suzuki ltz 250 quadsport the starter winds but does not engage it happened to be running fine then it died and just winds out when you try to start it any ideeas i dont know what year is but ...

rmz 250 09 model with new clutch cable fitted must be adjusted fully out to get clutch to operate Compare the old cable to the new cable. The outside casings should be the same length and the Inside ...