engine runs backwards? husqvara CRT 50 rear tine tiller 4.5hp briggs . starts good. runs for a few seconds. then starts sceeching and winds the pull rope backwards. Starter clutch needs to be cleaned ...
Question about PRRT850X 960920015 CA 17" Rear Tine Tiller
...Husqvarna CRT81 Rear Tine Tiller - the rope won't pull to start it. We used it about 2 weeks ago too.It's about 13 years old, but we have been using it quite a bit. I took the rope mechanism off and ...
...the gear box? I check the engine oil and change as nedded, but I don't find a zerk fitting anywhere, so I assume that there is a fill point for the gear box. This may help. Husqvarna tiller ...
...husqvarna rear tine tiller? Unless you live in a cold climate, ordinary 30W motor oil is fine. In cold climates, 10W-30 may make starting easier. You don't need expensive synthetic oil. Sounds like ...
Question about 14" Tiller with Briggs 900 Series Engine HVL CRT900
tiller today, used it a little bit then a loud grinding noise started coming from transmission We just bought the same one, it was delivered on March 3rd, we ran it March 4th and had the same grinding
engine surges Brand new tiller, less than 2 hours on LCT 208cc engine. Starts ok, brand new sparkplug, ok. Engine warms up ok but when put under load the engine start to surge immediately. sounds like
husqvarna ft900 won't start put new gass in, replaced spark plug, sprayed with carbarater cleaner did you open the choke all the way? also, what was the temperature when you attempted this at the ...
Where is the air intake Husqvarna 650 RTT? I have some starter fluid, because of the cold. I need to know where the air intake is located, to use the spray accordingly. Thanks! there is a reason it's ...
Question about 650RTT Tiller / Cultivator
my husqvarna tiller wont start after sitting all winter -Make sure there is fuel. Good luck mai
Question about PRRT850X 960920015 CA 17" Rear Tine Tiller
When I try to start the tiller (9hp Honda) the rope will kick back hard jerking it out of my hand Ed. the key way on the shaft to flywheel could be sheered throwing timing way off, which does this ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions