Questions & Answers for: husqvarna stop switch

...Husqvarna Rose embroidery unit working fine 2 weeks ago. Now it goes for a few minutes and then the unit stops but the needle keeps going up and down on the spot. The only way to stop the machine is ...

...switch The stop switch broke off on my Husqvarna 36/41, 16'' bar and I need to know where the hookup is one end of the blue wire goes to the ignition coil and the other end goes to the stop

stop button not working My Husqvarna 350 chainsaw will not stop unless i use the choke. do you have any suggestions on how to fix that problem? A stop button is just an on off switch or a monitary off

...to be getting hot and clutch will pull in everytime until switch gets hot. I have a husqvarna yth2448 mower whitch the pto switch burns out and pull apart .Blade stop turning and mower remains ...

husqvarna 36 chainsaw that starts and runs just fine. However, the stop switch doesnt seem to work. I push the switch to stop and the saw continues to run. The only way to kill it is to use the choke.

Husqvarna 445 start/stop switch won't stay in choke I just bought a refurbed Husqvarna 445. I got the bar and chain on, filled up with gas and oil, but I cannot get the start stop switch to stay ...

husqvarna 415 machine sews 3-4 stitches at same speed then stops will start again after 15 secs for another 3-4 stitches could be a safety switch problemtry changing the needlerethread the machine top

Husqvarna chain saw 345e EPAII. When i push the switch down to stop it, it doesn't. I removed the cover and a saw a wire (female connection)disconnected, but I don't see where thi Hi, I have a

husqvarna.net/documents/HUSI/HUSI2018_NAenNAes/HUSI2018_NAenNAes_115808096_2018-04.pdf The PTO clutch is powered from the A1 (accessory 1) terminal of the ignition switch via the PTO switch. Check for