Questions & Answers for: husqvarna cut saw spark

husqvarna chain saw...started and then cut out...drained and replaced gas/oil and replaced spark plug. Now it won't start at all don't know what to do...please help check your pick up coil . i had one

...husqvarna 385 saw. It starts good, idles good, but as soon as you rev the saw it starts to cut out and runs very rough. but returns to a perfect idle. Sounds like dirty carberator or carb needs ...

...saw cut out and would not start. Left for half an hour and saw started, run for half a tank of fuel then stoped, now cannot start. Seems to be fuel getting to the spark plug, replaced with new spark ...

...saw cuts out on high revs Many saws made today are using electronics for engine control. If the engine rpm's starts to rev to high, the electronics in the coil will start to 'cut out' some of the ...

...husqvarna k960 won't start I have spark on the sparkplug but i whant start i know you would like a simple solution. these saws are not simple. check gas for water, clean air filter, check exhaust. ...

cut off saw and there is no spark going to the spark plug. The switch is on, and I put a new spark plug in. Do you think it might be the coil. Rich first make sure the switch is good and the wires are

...Husqvarna 136/141 saw. As soon as I either operate it to max feewheel speed or require full power when sawing the engine stops. This first occurred when cutting a large oak beam recently. I have ...

cut off saw three new air filter,gas filter,spark plug saw loses power after 15 sec of hvy cutting Piston rings are gaulded or stuck, easy to change and fairly inexpensive if you buy aftermarket parts

Change plug an won't start Make sure you have the correct spark plug for your maching. and Make sure the gap is correct on the spark plug. Look in your owners manual for the correct gap. Check inside ...

...husqvarna 385 saw we start it cuts good soon as get hot it not want to cut it dogs out clean carb new lines new spark plug What may be happening is that the carburetor is set too lean, not enough ...