Questions & Answers for: husqvarna chainsaw stops hot

if you have good compression you need to take the muffler off and look to see if the piston is scored.Call husqvarna hot line and they will give you the nearest husqvarna dealer to repair it correctly

Husqvarna chain saw starts and runs for 20 minutes then stops. Saw starts fine and cuts for about 20 minutes. Then it starts to sputter and stops. I can restart and idle but won't run when I press ...

ran for a while, got hot, stopped, cant restart.Help my poor baby! It depends on how hot you got it. Remove the muffler and check for a scored piston and cylinder.

...thne stops no spark chainsaw cuts 10 times thne stops no spark No spark is either a bad ignition coil *(dies when it gets hot) or, if you still have points and condensor, time to replace those

husqvarna chainsaw stops when using it chainsaw starts and runs fine then after about 10 minutes use stops and wont restart, but leave it to the next day starts and runs for another 10 mins. its had a

...chainsaw enthusiasts. You might be able to find some used parts. There are threads that discuss using acid to clean up a cylinder. Please try a search, find an applicable thread and join in, New ...

...stops suddenly. does not run down as it would with a fuel problem. Only happens when it is hot. Then it is impossible to start. I think your ignition module is failing when it gets hot; rare, but it ...

always have to stop to tighten chain I tighten the chain prior to running it. After about 10 minutes of running it, I have to stop to tighten the chain again. It continues to do this every ten minutes

562xp backfire loss power 562xp ran hot into 36inch log made one pop/back fire then loss power until held level and no pressure cut ok for minete and did backfire and pop again a loss of power There ...

...Husqvarna 351 starts then stops after 1-2 seconds After running through a tank of fuel my chainsaw starts and then stops after 1-2 seconds. The fuel is fresh but the saw is slightly warmed up from ...