Question about "Chain Saw - 16" Bar, 3 Hp
...husqvarna Model 254 chainsaw This saw runs sluggishly when in hard timber. Not sure the size bar/chain are original. What is recommended? Maximum bar size of 20" but would recommend 18", if it is ...
...husqvarna 385 saw. It starts good, idles good, but as soon as you rev the saw it starts to cut out and runs very rough. but returns to a perfect idle. Sounds like dirty carberator or carb needs ...
Question about "Chain Saw - 16" Bar, 3 Hp
...husqvarna chainsaw 435 what type of tool do l use to adjust t screw? Where can i get it? the screws are on the side of the carb very small heads flat screw driver is needed as they have a cover on ...
Husqvarna Model 136 chainsaw will only run for a short time with choke closed. Engine quits shortly after choke is opened. Take apart the fueling system and carb. Something is blocking or gummed up. ...
...husqvarna 51 chainsaw? the "H" is the high rev setting the "L" is the low or tick over setting and there set up when the engine is hot and running,,,first the high rev ste up tweek the screw till the ...
Question about "Chain Saw - 16" Bar, 3 Hp
...husqvarna 61 chainsaw wont start getting spark. fitted tillotson carburator repair kit, still wont start. starts for a few revs then cuts out.sometimes carb floods out of top hole in carb. have not ...
Husqvarna 266xp issues. my husqavarna 266xp runs great.. starts great.. just had a tune up but seems to be lacking power until the end of the fuel tank. could this be a carburetor issue or the ...
...husqvarna You need a special tool to adjust the mixture screws, i have to say they are not easy to tune, you will also need a rev counter to set the high revs, it is very difficult to give basic ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
husqvarna 61 vibrates badly when idling.Various things keep coming loose. Tried locktight. 2nd problem is slow to idle from full revs, sometimes won't idle, will cut out when turned chain side down. ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
Husqvarna 435 chainsaw starts easy and revs up fine. Hold it wide open and has uneven miss. Changed spark plug and cleaned carb. New saw, 1 tank of gas. Also checked seals. Any Ideas Have you checked ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions