Carburetor problem How to adjust carburetor husqvarna 136? Hi High speed H=3\4 turn Low speedL=1 1/4 turn idle speed t adjust accordingly. regards savumihai71
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...chainsaw starts right up idles fine but it doesn't seem to rev as high and as soon as it hits wood it bogs down and just wont cut for ****. I have changed fuel filter air filter and spark plug. There ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...husqvarna 55. I put in a new carb, coil, gas line, spark plug and gas filter. It starts but will not run off of idle. Tried h-speed idle screw w/no success. Looking for help please. What is the H/L ...
i have husqvarna 570 chainsaw that idles but wont run full throttle Check all idle settings, if its ok and problem is not sloved check all carburattor gasgets.
Husqvarna 55 chainsaw has a problem running on idle The saw starts O.K. and runs so fast that the clutch stays engaged. The engine runs irregular and the machine vibrates. When I adjust the L for the ...
husqvarna problems model 445 will not run idle down, runs at full speed check the linkage first...
Question about 435-BRC-RB Chainsaw
my 435 starts perfect but will not idle whats the problem carb settings are out of wack. try turning your idle screw up 1/8 of a turn at a time until it idles at a reasonable rpm and the chain not ...
Question about 435 - 16" 41cc Consumer Chainsaw
my 435 starts perfect but will not idle whats the problem If ste saw revs up but dosent idle you most likely have a clogged low jet in the carb.
Question about 435 - 16" 41cc Consumer Chainsaw
husqvarna 61 vibrates badly when idling.Various things keep coming loose. Tried locktight. 2nd problem is slow to idle from full revs, sometimes won't idle, will cut out when turned chain side down. ...
Question about 435 - 16" 41cc Consumer Chainsaw
...Husqvarna pre-mixed fuel since new. And is getting very frustrated with this sawMe too Electronic ignition in a chainsaw--come on now! It's a chainsaw! Pull vacuum and pressure test to see if the saw ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions