Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...muffler. If it is clogged with carbon you can clean it with a stiff bristled brush. Also, check fuel lines for pin-hole leaks or cracks that are masked in the bends of the fuel hoses. Richen the ...
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...then: Remove Carburetor 5) replace gaskets/diaphragms b) use a spray carb cleaner to clean jets, holes, and body of ...
Question about Inc. 25.4 CC Backpack Blower
...then: Remove Carburetor 6) replace gaskets/diaphragms a) use a spray carb cleaner to clean jets, holes, and body of carb b) fuel pump diaphragm goes against the carb body, then the gasket towards ...
Question about ECHO, Inc. PB-251C Handheld Blower
...Please advise as soon as possible. Thank you check your exhaust (muffler), it has 4 or 5 small exit holes, the new gasket between the exhaust port and "muffler" has been known to come apart and plug ...
...? have you checked that the tank breather is working, and that the fuel pump diaphram is ok - no holes or damaged / stiff , and also that the metering diaphram and needle valve are ok and are not ...
...found the problem. If it still pulls hard...check the exhaust port of the cylinder head for 2 tiny holes (not screw holes) Some have them some don't depending upon the year of the saw. If you do ...
Question about Gas 20 In Blade Double Reciprocating Double Sided Hedge Trimmer SHC225
...muffler off drilled small hole in honeycomb baffle and took little screen out. After drilling little hole it ran good for bout 5 mins. I took white cap off breather line took rubber piece out checked ...
...hole . also checked muffler screen,was clean. there was quite a bit of fuel in muffler.cleaned plug put back together still wont start.pump bulb fuel fills clear tube.seams to have compression and ...
Question about ECHO, Inc. PB-251C Handheld Blower
...muffler removed.... help remove your spark plug and try to pull over. if it still won't turn over then you will have to decarbon your head or you have vapor lock so then with plug removed pull recoil ...
...muffler to inspect piston face for scoring. look for carbon build up in exhaust port 2) Inspect spark arrester screen for carbon plugging. If so, clean with wire brush 3) Check the impulse line or ...
Usually answered in minutes!
116 Questions
71 Questions
111 Questions
76 Questions
19 Questions