... With the door still open hold down the go button for 1 second 6. Put the toner/drum unit back in 7. With the door still open hold down the go button for 1 second 8. Close the door and press go to ...
...Hold the drum at the ends and never touch the drum surface. ? After removing the drum, keep it in the drum case or storage bag to protect the surface from light. Prucedure 1. Remove the image ...
...6 or so months of production the drums are heldon by a large nut and the drum and bearings are one piece unless you have a press. It will be a little tough to get off and a slide hammer does wonders. ...
Question about HL-2040 Laser Printer
...6 times on one printer and it still goes fine . 1. turn the printer off 2 . check that the front cover is open 3 press and hold the go button and while holding turn the printer on . 4.check that the ...
...pump. if you find this and clean it out you will be good for another 6 months...its important to check pockets before washing This is normal. These machines always hold a slight amount of
...paper. You will need to replace the drum every 5-6 toner cartridges you use. This means that the ink of the toner or drum is near to finish. Please refill your toner or drum ink as soon as
Question about 98702 Stacked Washer/Dryer
...6 screws inside the dryer drum. Three toward the center of the back hold the drum to the socket bearing. The three further out hold the heating element housing to the drum. With two of the bearing ...
6) As soon as the lights get OFF, release GREEN GO BUTTON 7) Now immediately press and hold RED CANCEL BUTTON 8) Again immediately press and hold CARTRIDGE SELECTION BUTTON 9) Now release the last two
6 times, and on the drum unit slide the blue/green tab on the far left side from left to right for 6 times also. reinstall the toner back to the drum unit. reinstall drum and toner back to the machine
Question about Hl2240d - Hl-2240d Laser Printer With Duplex Printing - Laser Printer
cover of the printer 5.Press and hold down Go button for about 4 seconds until all the LEDs light up. 6.Once all 4 LEDs are lit, release the Go button 7.Close the front cover. 8.Your drum is now reset
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions