Questions & Answers for: hobart handler wire feed motor

Question about Handler 140 Mig Welder

Hobart 135 wire feed sped control problem

hobart 135 wire feed sped control problem The wire feed speed control runs at full speed regardless of the knob position. I checked the potenciometer and the ohms vary as the knob is turned but the ...

Question about Handler 140 Mig Welder

1 Answer

Hobart handler 135 feed motor for wire doesn't

hobart handler 135 feed motor for wire doesn't feed wire. motor is ok I tested it with seperate power source. No power to motor from main board or ?????? check the SCR ,looks like a big transistor ...

Question about Handler 140 Mig Welder

1 Answer

I have a hobart handler 135 motor stops feeding

...hobart handler 135 motor stops feeding hold the trigger runs for a couple of seconds then slows to a stop. motor acts powerful for that few seconds unplug plug it back same thing let it sit for a ...

Question about Handler 125 Ez

1 Answer

Need to try and find a wire feed motor for Hobart 120

Need to try and find a wire feed motor for Hobart 120 Handler.Mine is smoking.I think its a 1997. Thanks go to praxair ,air gas s j smith or any welding shop they can get it for you,

Question about Handler 140 Mig Welder

1 Answer

Hobart 175 ,pull trigger relay clicks have 24

hobart 175 ,pull trigger relay clicks have 24 volts to motor ,but motor dont run take motor out and it runs great has torque ? put meter on motor leads with it hooked up and when pulled trigger ...

Question about Handler 140 Mig Welder

1 Answer

Wire feed motor will not run even without the wire

wire feed motor will not run even without the wire Wire feed motor will not run even without the wire in it. Probably the bridge rectifier. I had a 120 and thats what happened to it...

Question about Handler 140 Mig Welder

1 Answer

Have Hobart 140 Handler, The

Hobart 140 Handler, The motor won't run to feed the wire, even whith out wire. gas will come on when trigger depressed.Where can I find parts to fix? You need to look at the wiring diagram to see what

Question about Handler 140 Mig Welder

1 Answer

Hobart handler 135 wire feeds for about a two feet

hobart handler 135 wire feeds for about a two feet then stops feed motor runs well under no load This happens to me all the time. Wear and tear has taken its toll and everything has to be maintained ...

Question about Handler 140 Mig Welder

1 Answer

Wire feed is not stable on Hobart handler 135

...Hobart handler 135 is this a lower end machine ? the cheaper machines take the power from the welding transformer to power the feed motor and as a result the feed isn't stable, also is the wire liner ...

Question about Handler 140 Mig Welder

1 Answer

My motor on my hobart handler 135 is not working to make the wheels roll to feed wire. I disconnected it at the connectors and tested it and was not getting any readings on my meter as if it was not g

hobart handler 135 is not working to make the wheels roll to feed wire. I disconnected it at the connectors and tested it and was not getting any readings on my meter as if it was not g The numbers on