Hobart handler 135 works but the weling wire is stuck solid inside the feeding tube I have pulled on both ends and the tips are gone now , the wire is still inside is there a way to pull the wire out
...Hobart 135? I would love to find a direct location to order this internal parts. hi if the set cuts out after 10 /15 min on full power the thermal cut out switch is doing its job if it cuts out after ...
Question about Handler 140 Mig Welder
the speed will not adjust on the wire feed. hobart 135 i changed the variable controller and the speed still only goes full speed only. Diode get one from your miller welder supplier
hobart 135 wire feed sped control problem The wire feed speed control runs at full speed regardless of the knob position. I checked the potenciometer and the ohms vary as the knob is turned but the ...
hobart handler 135 feed motor for wire doesn't feed wire. motor is ok I tested it with seperate power source. No power to motor from main board or ?????? check the SCR ,looks like a big transistor ...
Have a Hobert handler 135 i can't control the wire feed speed it seems to run wide open. Sounds like the restate that controls the wire speed is gone. Replace it.
hobart handler 135 wire feeds for about a two feet then stops feed motor runs well under no load This happens to me all the time. Wear and tear has taken its toll and everything has to be maintained ...
Hobart handler 135, the wire starts to feed for about 15 seconds then slows and stops. Hi:Don't know how old is your unit but my guess is that your gun's liner is the problem. Have you change ...
...Hobart handler 135 is this a lower end machine ? the cheaper machines take the power from the welding transformer to power the feed motor and as a result the feed isn't stable, also is the wire liner ...
Question about Handler 140 Mig Welder
...Hobart handler 135, just changed the wire, the correct size. Now the wire feeds super slow, when you turn up the speed it kinda works but just clumps my welds, what should I do to fix this? check for ...
Usually answered in minutes!
111 Questions
70 Questions
52 Questions
49 Questions