Questions & Answers for: high side port leaking

Question about Laars Lt 250,000 Btu Heater

0 Answer

high limit makes contact with while sitting in the chamber. It does not have any threads but I can't understand what was holding this piece in as the other side of the brass piece has pump pressure on

Ad

Question about 2001 Escort ZX2

2 Answers

...side port, it will not fit on the high pressure port. Be careful not to over charge the system, and if you need to recharge it again with in2 weeks then you have a leak then needs to be addressed and ...

Ad

high-side fitting is the largest and special couplings are required to connect service equipment to both the high-side and low-side service ports. Refer to Special Service Equipment as outlined. Quick

...high pressure side. Do not try to recharge it unless you are 100% sure. If you are needing to recharge the system then it has a leak that needs to be repaired. It is technically illegal to add ...

high side port is located where the front grill meets the upper radiator support. I hope this helps you out. And also if you are looking for a leak, check the snout seal located under the outer clutch

Question about 1994 Ranger Supercab

2 Answers

...high pressure side .. the large tube is the low pressure side ... follow the large tube back until you find a cap that covers the low pressure port .. thats where you would fill with new refregerant ...

Question about 2000 Grand Cherokee

1 Answer

aprrox 1.75 lbs with proper gauge (28 ozs). Leak points are many, low side port ,high side port, high and low cut off switches,evap inlet,compressor manifold,condensor inlet and outlet...to name a few

high side port just beside radiator on passenger side and low side port is located on the accumulator right next to clutch cycling switch low side freon port is one the recieverdrier. passengerside>

Question about 1999 Silverado 1500

1 Answer

high side port leaking I have a 99 Silverado which I was just charging with 134 when I noticed the high pressure port was leaking. Can I replace the port or the valve core myself or is it a big deal? ...

high side. You NEVER want to charge from the High Pressure side. The low pressure charging port should have a black cap on it and should be found on top the the receiver/dryer, a bottle-looking device

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

David Spradling
David Spradling

Level 3 Expert

13520 Answers

Are you a Pool & Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...