Questions & Answers for: what do i do when it has a high rev

rev high when changing gear up I have just brought a 2003 CR-V ITEC SE and have noticed that when changing up through the gears with the clutch down high rev are noticed, they drop after two - three ...

Car revs high when not in gear, but still revs when you start the car everything is normal or it seems. After it warms up the car revs high when not in gear, but still revs higher than normal when it ...

runs lumpy at low revs, high revs o.k., zx9r 's' runs lumpy at low revs, high revs o.k., changed plugs ,coil res. check o.k check for vacuum leaks and vacuum balance carbs And check the carb ...

l50deto 2 stroke outboard stalling at high revs L50deto 2 stroke outboard stalling at high revs. Revs ok when timing advances, but as soon as throttles on the carbs open much it stalls rapidly. Carbs,

i only just brought it v6 1991 wont rev out clean dies down at high revs it has a rev limitor on it.. at high revs the computer shuts the engine down to prevent damage.

honda spada vt250 I have a VT 250 Honda Spada. At low revs it sounds fine but at high revs it has what I think is a loud rattle . It also dies with power at around 7000 revs . I do know that the air ...

engine high rev's I replaced the plugs with the wrong ones and it rev real high then I put n the right one and now it rev's high and stalls? Check for a vacuum leak!

rev high, it shows code c3fa9 my car does not want to rev high, it shows code c3fa9 on scan tool if it will not rev high , it could be in the limp mode or the rev limiter has failed find what the code

...high rev at start up - JeepForum.com www.jeepforum.com > ... > WJ Grand Cherokee Forum Jun 15, 2011 - 15 posts - ?7 authors anyone know the cause of high rev to 2K rpm at start up? just recently ...

...rev high. It's recommended to have a professional mechanic diagnose the issue using an OBD-II scanner to retrieve the error codes and perform a proper diagnosis. Based on the error codes and the ...