...high mount brake light does not. Replaced fuses wit new fuses. Circuit tests all indicate no circuit problems, lose connections, shorts or ground loops. Is the hign mount brake light standard type ...
...high mount brake light for the 2008 Hyundai Sonata must have been in a crabby mood that day. That being said, there are two screws accessible from the trunk area. They hold the light housing and ...
Question about 1998 Seville
...high mount back light strip is not lighting up when i step on the brake check the lt blue wire at upper lamp,(under trunk lid trim panel) for 12 volts when brake is applied. if no voltage,check same ...
Question about 2001 Expedition
...and switch output is applied to the three high mount stop lamps. If the regular stop lamps work when the brake pedal is pressed, the switch is OK. All three high mount stop lamps may have burned ...
Question about 2001 Expedition
...high mount stop lamp. Power from the closed switch also is applied to the multifunction switch to turn on the stop filaments of the combination park/stop/turn lamps. If the fuse is OK and the high ...
...high mount stop light not working? Bulb is not fused The same 15amp fuse for the regular brake lights powers the high mount light. If the regular brake lights work but the high mount does not, it ...
Question about 2003 Corolla
...Refer to High Mount Stop Lamp Replacement . Did you complete the repair? Go to Step 20 -- 20 Operate the system in order to verify the repair. Did you correct the condition? System OK Go to Step ...
Question about 2003 Corolla
...high-mount brake lite work? The reason I asked, the high-mount brake lamp and lower brake lamps are wire differently. The lower brake lites are wiring through the turn signal switch. bbbind.com has ...
Question about 2003 Corolla
high mount stop lamps , wiring etc.... Causing problem inside the BCM . Do you know what wiring diagrams are ? Free one's here http://www.bbbind.com/free-tsb Enter vehicle info. year , make , model an
Question about 2003 Corolla
...brake switch. The BCM then supplies battery positive voltage to both left and right stop lamp assemblies and to the center high mounted stop lamp (CHMSL). Which one isn't working ? Left - right or ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions